How To Cut Crown Molding Angles For Kitchen Cabinets

How to Cut Crown Molding Angles for Kitchen Cabinets

Crown molding adds an elegant touch to any kitchen, but cutting the angles for a perfect fit can be a daunting task. With the right tools and techniques, however, it's a project that even novice DIYers can master.

Materials and Tools

* Crown molding * Miter saw * Protractor or angle finder * Measuring tape * Pencil * Sandpaper or sanding block * Wood glue * Clamps * Nails or brad nailer

Measuring and Marking the Angles

1. Measure the length of the wall where the crown molding will be installed. Cut the molding to that length using a miter saw. 2. Determine the angle at which the molding will meet at the corners. Use a protractor or angle finder to measure and mark the angle on both ends of the molding.

Cutting the Miter

1. Set the miter saw to the marked angle. Make sure the blade is sharp for a clean cut. 2. Place the molding flat on the saw's table with the marked edge facing down. 3. Slowly lower the blade onto the molding and make the cut.

Fitting and Securing the Molding

1. Dry fit the cut pieces together to ensure they meet at the correct angle. If necessary, adjust the angles slightly using a sanding block or sandpaper. 2. Apply wood glue to the inside edges of the miter joint. 3. Join the pieces together and clamp them securely. 4. Drive nails or use a brad nailer to secure the molding to the wall or cabinets.

Tips for Success

* Use a sharp blade for clean cuts. * Measure carefully and double-check your angles before cutting. * Dry fit the pieces before applying glue to ensure a perfect fit. * Use a small amount of wood filler to fill any gaps or imperfections. * Prime and paint the molding to match the kitchen décor.